Interested to Buy Any Domain ? << Click Here >> for more details...
CONSIDER A 415V/200V STEP DOWN TRANSFORMER.CAN WE USE USE
IT AS STEP UP TRANSFORMER BY GIVING 200V IN SECONDARY AND
TAKING OUTPUT FROM PRIMARY?
- 22 Answers
- 29397 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / vinothbhabu.k
its not possible,the while designing the the transformer we
should calculate the capacity of load,according to the
load the insulation level oil level be designed,so its not
possible one..
| Is This Answer Correct ? | 1 Yes | 12 No |
Post New Answer View All Answers
How can ou verify the size of conductor 50Sq.mm ACSR
What happens if we connect a single phase energy meter in reverse polarity.
why US countries maintains 110v and 60HZ
how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?
when will be the iocl interview results ifaced the interview on september 8 th
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
How to calculate the size of earth cable to earth the neutral of UPS ?
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
Explain how you decide what size of electrical wire do you need?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
why are the maintaine power factor and how can this control and this is how work.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
