Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between isolation and insolation ?
please explain in detail with example.
- 5 Answers
- 24509 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / mahesh reddy
Isolation: It means saparation between equipment and main
supply.When we want to maintain a particular equipment it
should be isolate with mains supply.Other wise we can not
maintain it.
Insulation: It means an isulating material is provided on
the (live) cables or equipment according to their voltage
rating to avoid short ckt b/w live parts and earth faults
b/w live part and ground. This for our safety as well as
equpment safety.if it is not provided may cause so many
electrical hazards or limit the usage of cables in various
places.
| Is This Answer Correct ? | 30 Yes | 10 No |
Post New Answer View All Answers
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What are the conditions to be satisfied for parallel operation of dc generators?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
what is static frequency converter?what is the function...of sfc...?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
how do you choose the cable size as per amps rating & the voltage drop for the same.
What are the essential characteristics of signal flow graphs?
How much of the total hydro power potential has been exploited so far in india?
How to calculate phase to phase difference ?
What are the functions of different probes used in cro?
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
how to extend relay operating timing in 24V dc relay card (without using Timer )
in dc series motor if field wdg is shorted then
