Answer Posted / phani
it will form corossion to that sheet metal due to the
formation of fe2o3.
The metal will become unfit in future.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How is natural gas better than lpg?
Explain important rules that must be kept in mind while designing castings?
What is the difference between austenite stabilisers and ferrite stabilisers ?
why it is difficult to make heavy cuts if a form turning tool is complex in shape?
After any cause of repaired how i start the engine by slow speed 800 to 900 rpm electronic control moudle engine [cummins]
How to check temperature controller?
why we transfer FA(full arc) to PA(partial arc) in steam turbine at specified load?
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
3x3x2.5 m room temperature increases by 20 deg cel in 24 hours by a lamp of 100 w. then tell the temperature of the filament
What are the minerals needed to make or build a car?
Explain the difference between ferrite, austenite and graphite ?
How to check the round duct measurement
How the net work to drive a compressor and its volumetric efficiency behave with increase in clearance volume ?
how can i replace annular plats in tanks
what is the basic need for designing the bottle filling machines
