What type of protective system we uses in L.V. distribution
panels?
- 6 Answers
- 7638 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinod
VCB,ACB,MCCB
| Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
Show the schematic arrangement of diesel power station layout and give its principle of operation.
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
how to calculate the lightning arrester conductor @ no of earth pits required
WRITEDOWN FEW RELY CODES
What is load boxes ?
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
Thumb rule of cable size(rm>30 rm)X multiplying factor=ampere
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
what are the major & minor faults that occur in an inverter and in UPS ? And how to repair and resolve them ?
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
