Answer Posted / omprakash
neutral is return path earth is a zero potential
| Is This Answer Correct ? | 28 Yes | 3 No |
Post New Answer View All Answers
What do you mean by reach and reach the point of the relay?
along with technical test papers
why Induction Generators are not "Black start" ? and apart from WTGs where this types of generator are generally used?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
What is vaccum currcuit breaker.define with cause and where be use it device?
State The Difference Between Generator And Alternator?
How to select the cable and voltage drop in circuit?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
What test must you do before powering up a circuit that you have been working on?
IN 1000kva transformer where the oil and winding temperature sensors is connected