Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vikrant gokul labhane
NO,We can not step up DC power using transformer.
DC having both potantial (ie.+ve &-ve )and when it is
connected to primary wdg. of transformer ,primary get short
ckt.& burned (Heat wiil produced).
BUT THERE IS ANOTHER WAY -
* First convert DC power into AC power by using inverters &
after then that AC power can convert into DC power by
rectifire at suitable range as you required.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What are the properties of a resistor?
lorteny method
How to calculate approximate load loss of a distribution transformer by knowing %ge imp of transformer?
what is the purpose of shading ring or shading coil in electrical equipments.
what is interfacing in computer studies?
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
how the characterstics of control valve being done
Initially, when the input is not equal to the output — what type of response is this?
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
A logic circuit that provides a HIGH output if one input or the other input, but not both, is HIGH, is a(n)?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
Differentiate between low pass, high pass and band pass filter?
physical identification of HT & LT panel
