When you cords an IP address on a place router which command
stale the IP processing on the interface?
A. ip enable
B. network ip-address
C. ip address ip-address subnet mask
D. the exit command from the enabled configuration
E. copy running-configuration to startup-configuration
Answer Posted / guest
Answer: C
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the beaconing?
Name the command we use for ping in ipv6?
Can you explain tunneling?
What are the different memories used in a CISCO router?
Define the multicast routing?
Which dynamic type draw back is, if single link down, it removes its routing table?
Can you explain PPP protocol?
Which classes are assignable?
Why twist in twisted pairs?
Define class full protocol?
What is topology in ccna?
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
What is hsrp?
What is the command for change serial cost?
Tell me which protocol works only on cisco routers?