Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE Differance b/w on/off & pid control valve?
- 10 Answers
- 38706 Views
- I also Faced
- E-Mail Answers
Answer Posted / ytd
ON/OFF CONTROL VALVE WORKING IN TWO MODE EITHER ON OR OFF.
In ON off control process has shoot up and down. This
process is not suitable for critical processes.
E.G.controlled heating / cooling for Annealing cycle.
PID control generally used in close loop process where
feedback of output is used to correct the input depend upon
the desired process.
S(o/p)= S(i/p)+/-(S(correction).
From this simple equation o/p signal is corrected but
depending upon the responce of the process `Diffential
gain' or integral gain is introduced and this simple
equation is modified.
Depending upon the process performance responce time ang
gain values are to be programmed in the PID controller.
Then PID controller follows the equation to make process
more controlled.
| Is This Answer Correct ? | 51 Yes | 8 No |
Post New Answer View All Answers
How many interlocks at turbine? Plz explain briefly
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
components of control circuit belongs to control valve
Why mixer nd grinder Is example of constant torque load not variable torque load ???
can anyone tel the syllabus or previous year question paper for BHAVINI(EIE)2014.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
the output of the common trasmitter protocol in qatar gas are the following
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
what is the difference between attemperator and desuperheater ?
How to erection of DCS Panel at site step by step
what is effect of specific gravity in differential level transmitter , explain formula related with this .
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
What are the uses of orifice plates?
