Which command specifies a second subinterface on serial
interface 0?
A. interface s 0.2 point-to-point
B. interface 2 s.0 point-to-point
C. suberinterface 2.s 0 point-to-point
D. interface s 0 sub 2 point-to-point
E. interface s 0.1 point-to-point sub 2
- 2 Answers
- 6088 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: A
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
Utilizing RIP, what is the limit when it comes to the number of hops?
What is ad in ccna?
Explain the benefits of vlan?
What is the draw back of eigrp protocol?
In stead of 0.0.0.0 wild card mask what you can write after ip?
What s the formula for metric of ospf?
What is the network subnet?
Tell me when we use extended access-list?
What is formula of hold down time of eigrp protocol?
Which dynamic type draw back is, if single link down, it removes its routing table?
Explain what are partial updates?
Can you explain static and dynamic tunnels?
Mention the ranges for the private IP?
Explian what is a node?
What is the minimum and maximum request timer?
