Interested to Buy Any Domain ? << Click Here >> for more details...
what is skin effect? why is it absentin dc system
- 22 Answers
- 46162 Views
- I also Faced
- E-Mail Answers
Answer Posted / biswajit ghosh
AC current tends to avoidtravel through the centre of solid
conductor.electrons switching directions of flow,on other
hand ,tends to avoid travel through the very middle of a
conductor, limiting the effective cross-sectional area
available . the skin effect becomes more pronounced as
frequency increase.
| Is This Answer Correct ? | 3 Yes | 14 No |
Post New Answer View All Answers
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
what are the types of electromagnetic forces developed in practical transformer?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
Why is better to have a minimum ceiling voltage of 250% than 160%?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
There is any especial requirement for motor to drive through with VFD?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
Basic motor transformer generator
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
Give some differences between open loop and closed loop?
why using transformer and thyristor switch in 3 phase apfc panel
