Interested to Buy Any Domain ? << Click Here >> for more details...
why we generally use 3.5 core cable or in other word 1/2
core for neutral and also confirm me that in balance
conditiob(3 phase)current in neutral will zero
- 7 Answers
- 32753 Views
- HCIL, Jindal, Siemens, I also Faced
- E-Mail Answers
Answer Posted / dkmathur
In a three phase circuit theoritically there will be Zero
current in Neutral. But due to un-balancing of phases
practically phase voltage becomes unequal with the result
some current flows in neutral.That is why neutral is of
half rating only.
| Is This Answer Correct ? | 66 Yes | 12 No |
Post New Answer View All Answers
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
State ohm’s law?
what is high and low cut off voltage of BB and DG at SPS????????
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
State angle criterion.
Explain the working of any one cutting machine
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
how load of a turbo generator can be increased
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
How does the phase sequence controller works, how it identifies the phases? confirm working principle
what is effect of leading power facter on the system and billing
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
