why voltage drop will occurs in 3 phase line?
Answer Posted / deepika tola
Because any line has an impedance, and acc to a simple law
known as ohm's law, voltage drop, V=IR.. so wen ther is
resistance/impedance, any line, whether it be 3-phase, 1-
phase, d.c. or any new invention...... it WILL have a
voltage drop!!
Is This Answer Correct ? | 42 Yes | 1 No |
Post New Answer View All Answers
What is the basic of DTH.
in dc series motor if field wdg is shorted then
Pl. give me checklist for installation & commissioning of machine tool.
What happens if we run alternator on under frequency?
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
some time we open engine breaker 8.0 MW load but plant not trip. and another time engine open 4.0 MW load engine trip why? individually engine breaker open & individually emergency stop why difference?
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
What is self exciting?
Sate maximum power transfer theorem?
sir pls send the je exam - 2008 and other model question papers..
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
can the measured percentage error during calibration of single phase energy meter be negative?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.