Interested to Buy Any Domain ? << Click Here >> for more details...
can you give main difference between ELCB And RCCB?
- 38 Answers
- 172870 Views
- MCB Bank, Reliance, Wipro, I also Faced
- E-Mail Answers
Answer Posted / k.senthilkumar
ELCB:-An ELCB is a specialised type of latching relay that
has a building's incoming mains power connected through its
switching contacts so that the ELCB disconnects the power
in an earth leakage (unsafe) condition.The ELCB detects
fault currents passing from live (hot) to the earth
(ground) wire within the installation it protects. If
sufficient voltage appears across the ELCB's sense coil, it
will switch off the power, and remain off until manually
reset. An ELCB however, does not sense fault currents
passing from live to any other earthed body.
RCCB:-A residual current device (RCD), or residual current
circuit breaker (RCCB), is an electrical wiring device that
disconnects a circuit whenever it detects that the electric
current is not balanced between the phase ("hot") conductor
and the neutral conductor. Such an imbalance is sometimes
caused by current leakage through the body of a person who
is grounded and accidentally touching the energized part of
the circuit. A lethal shock can result from these
conditions; RCDs are designed to disconnect quickly enough
to mitigate the harm caused by such shocks.
| Is This Answer Correct ? | 206 Yes | 20 No |
Post New Answer View All Answers
Define demand factor?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
What is speed mode?
mccb service sittings be done?
how to calculate short circuit current for the busbar
a simple c++ program to calculate simple interst with its data members as private
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
What is EHT tariff or Power factor Tariff ????
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
I need bhel electrical test pattern & paper
defination of lines
why we change the direction of winding in rotor ?how we make the north and south pole?
Why can't we parallel Voltage transformer secondary circuits?
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
