You have a driver that drives a long signal & connects to an
input device. At the input device there is either overshoot,
undershoot or signal threshold violations, what can be done
to correct this problem?
- 4 Answers
- 14742 Views
- Intel, I also Faced
- E-Mail Answers
Answer Posted / nikki
a cdm clamp can be used at the receiver input to protect
the circuitry form overshoot/ undershoot
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the steps involved in preventing the metastability?
What is look up table in vlsi?
What are the different gates where boolean logic are applicable?
Cross section of a PMOS transistor?
What are the Advantages and disadvantages of Mealy and Moore?
What are the various regions of operation of mosfet? How are those regions used?
What is Body Effect?
What are the ways to Optimize the Performance of a Difference Amplifier?
Draw a transistor level two input NAND gate. Explain its sizing (a) considering Vth (b) for equal rise and fall times
How can you model a SRAM at RTL Level?
For f = AB+CD if B is S-a-1, what are the test vectors needed to detect the fault?
How logical gates are controlled by boolean logic?
Explain various adders and difference between them?
Explain about 6-T XOR gate?
Draw a CMOS Inverter. Explain its transfer characteristics
