whether a separate starter is used for a motor while it is
connected to a vvvf panel?
- 2 Answers
- 4306 Views
- I also Faced
- E-Mail Answers
Answer Posted / salil
Seperate Starter is not required as the VVVF Panel will
take care of starting the motor with its soft start feature.
ofcourse, in some applications, seperate starter is used to
provide the bypass system.since in case of vvvf panel
failure the motor can be operated through the starter.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
why ten delta testing is carried out on power transformer
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
What is the use of bundle conductors?
block diagram of 2 ups system connected in parallel mode?
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
what is the transformer turn ratio formula and give some examples?
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
