Interested to Buy Any Domain ? << Click Here >> for more details...
how to use single phase supply for a three phase equipement.
- 12 Answers
- 21204 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunny
with the help of ARNO CONVERTER we can use single phase
supply for a three phase equipment.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in ups
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
I want to know all basics of electrical engineering
what is per unit calculation?looking for simple and strong explanation thk u
What is meant by impedance? difference between high & low impedance ?
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
where the lexical paramater will use in fron end?
what is the use of piston rings in the engine used for a generator...........
How to calculate the heat load for a electrical room
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
