what is the function of commutator in dc motor?
- 52 Answers
- 166966 Views
- Aviation, HP, Raj Construction, TCE, University Exams, I also Faced
- E-Mail Answers
Answer Posted / muhammad aamir
it the part of dc generator.in dc generator two half rings
are used the purpose of these rings is to prevent the
direction of current as in ac thee are caled as commotator
| Is This Answer Correct ? | 32 Yes | 53 No |
Post New Answer View All Answers
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
how we calculate the dick for a pole?
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
why connecting surge unit in contactor coil
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
in dc shunt motor if field winding is shorted then
can we synchronize star system generators with delta system transmission line ? and how ?
What is the principal of motor?
what is the chemical name and formula of refrigarent R-134a.
How to assume answer to electrical questions
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
what is mean by D.O. in distribution line poles?
What is the exact minimum vale of voltage between an earth and netural which can damage or can do malfunction of the electronic equipments ? If this is mentioned in any book, pl.give reference.
