Interested to Buy Any Domain ? << Click Here >> for more details...
11kv/0.433kv, 2 mva , transformer , for protection and
metering how many CT/PT are required?
- 24 Answers
- 37029 Views
- Bhilai, I also Faced
- E-Mail Answers
Answer Posted / suresh
Total 16 CT/PT are required
| Is This Answer Correct ? | 0 Yes | 24 No |
Post New Answer View All Answers
operation of protection relay watchdog contact?
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
Why CBCT rating is 50/1A
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
what is difference between bus coupler and auto transfer switch
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what parameters are should nessary for control technic dc drive(in rolling mills)?
What is meant by celling voltage & current in excitor ?
how do you test tachos and servos
