Identify the 2 methods to modify the routers boot sequence?
A.) Setup program
B.) Boot system commands
C.) RXBoot
D.) Config-register
- 1 Answers
- 4760 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
Answer: B D
'Boot system' command the 'config-register' are used to
manipulate the
boot sequence.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Which cable called roll-over?
Define topology?
Which updates called incremental updates?
What is Transport and Tunnel mode?
What is the icmp protocol?
In port based access-list which command you give instead of ip?
What is the difference between named and extended acl?
What is the maximum value of administrative you can use?
what are the different symmetric algorithms?
Tell me which protocol works only on cisco routers?
What’s the easiest way to remotely configure a router?
What is ad in ccna?
Explain dhcp scope?
Tell me which cable called roll-over?
Define the different kinds of casting
