hw to find transformer is in normal position? whether its
in charged condition or not? except humming sound?
- 9 Answers
- 11639 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / bala123
Apart from Humming sound, we can found the following ways:-
1. OTI (Oil temperature indicator) shows the winding
temperature value
2.WTI (Winding temperature indicator)shows the winding
temperature value
but its not correct way because if we disconnect the TxR (after
some hours) charging both may show current values
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what are the advantages and disadvantages of oil filled cables over XLPE cables
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
how to extend relay operating timing in 24V dc relay card (without using Timer )
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
Haw to check conductivity of budbar
33kv substation lay out details & line to line & line to earth measurements
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
What is online and offline ups? how does it works?
