WHY IS THE SIZE OF HOLE OF THE EARTH POINT IN THE PLUG
POINT BIGGER THAN PHASE AND NEUTRAL
- 7 Answers
- 12663 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / parmar jignesh
EARTH POINT PLUG IS BIGGER , BECAUSE AS AREA IS MORE SO
RESISTANCE IS LESS & CURRENT WILL ALWAYS FOLLOW LOW
RESISTANCE PATH I.E WHEN ANY FOULT OR LEAKAGE CURRENT IS
THERE THEN IT WILL FLOW THROUGH EARTH POINT NOT THROUGH
PERSION OPERATING DEVICE, AS EARTH POINT RESISTANCE IS
LOWER THAN THE RESISTANCE OF PERSION OPERATING OPERATING
DEVICE
| Is This Answer Correct ? | 50 Yes | 6 No |
Post New Answer View All Answers
how does an encoder work???
which pump used in STP
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
In the magnetic fluxes, what is the role of armature reaction?
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
Why 9KV surge arrester having 7.65KV of MCOV?
How to know of any cable size if there are not written on cabl?
What is kirchoff ’s current law (kcl)?
Purpose of providing neutral isolation panel for parallel operation of diesel generator
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
How may I enrol or get admission to your program?
what is per unit calculation?looking for simple and strong explanation thk u
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
