Answer Posted / ramakrishna m
The selection of CT depends on the current ratings of relays
those are used in the protecting circuitry and also depends
on accuracy that circuitry requires.
| Is This Answer Correct ? | 10 Yes | 8 No |
Post New Answer View All Answers
How to calculate loses in transformer of 160 KVA ?
The slip during plugging operation is given by= A 1-s B 2+s C 1+s D 2-s
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
what is parellel power factor correction?
which capacity of RCCB used for five thousand watt electricity load?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
Explain using drawings what is reverse PID action w.r.t PID controllers.
State uses of different types of stsrters with different capacities of motors as below: a. up to 5HP b. above 5hp to 10hp c. above 10hp to 20hp d. above 20hp
Why can't we parallel Voltage transformer secondary circuits?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
how to measure earth resistance of a substation
