When a square wave is applied to primary of a transformer
then what will be output wave form of secondary ?
Answer Posted / shekhar
transformer doesn't change the waveshape it just changes its
value and also frequency remains same so obviously output
would be square wave with changed value depends on
transformation ratio
| Is This Answer Correct ? | 42 Yes | 48 No |
Post New Answer View All Answers
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
where is core-type and shell-type construction suitable for transformers ?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
difference between high and low impedance BUS BAR relay??
WHAT IS counter flux IN CT?
66kv under ground cable how to layaing in ground any special case two ckt r runing
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
How to improve fuel cell in a distribution system?
hii this is ranjith from hyd... i want to know what type of questions they ask in interview...and hw the interview will go..? what subjects thay ask specially for electrical engg students?
what are the dimensions for 200 kva transformer plinth (plateform),in which pcc m20 is used..
HOW TO CALCULATE THE REGULATION OF 100 AND 25 KVA TRANSFORMER
why we use circuit breakers for switching instead of normal switching device?
calculate external resistance values to add to the rotor of a slip ring induction motor. STATOR- 415 V, 3 phase delta, 1100 A, 50 Hz, 1490 rpm, pf 0,86 ROTOR - 660 V, 590 A, 50 Hz. STATOR current at each steps STEP1-600A,STEP2- 800A,STEP3-1000A,STEP4-1100A.