When you cords an IP address on a place router which command
stale the IP processing on the interface?
A. ip enable
B. network ip-address
C. ip address ip-address subnet mask
D. the exit command from the enabled configuration
E. copy running-configuration to startup-configuration
- 3 Answers
- 4954 Views
- I also Faced
- E-Mail Answers
Answer Posted / nilesh
cords
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between igp and eigrp?
What is overlaod?
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
Explain the term 'unicast'.
What is the difference between cross cable and straight cable?
What is the network brouter?
Why ip address called logical address?
What is trigger rip and from which ios version it starts?
What are some standards supported by the Presentation layer?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router router?
What is the minimum request timer?
When we do default route?
What is the difference between the switch, hub, and router?
What are the advantages of a layered model in the networking industry?
What is collision?
