Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if we give 220v supply on both sides to the bulb
- 7 Answers
- 10989 Views
- Exide, Sumeet Industries, Toshiba, I also Faced
- E-Mail Answers
Answer Posted / ashutosh pati
If we gave 220v supply in 2wires then supply ism 415v then the both side of bulb is not working for short time and the filaments are nit work. The bulb rating is limited.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is counter poise conductors
What current position are you holding in your current company?
What is meant by reactance voltage?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
What is corkscrew rule?
in shunt clippers why a resistor is used in sereis with the input
What is Load sharing of Transformer ?
how to deside the capacity of chock for drive?
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
Between educational qualification and practical work experience, give us a brief explanation on your practical experience in your past Endeavour that you performed well to the satisfaction of your past or present employer?
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
USE OF 8 WAY PAN ASSEMBLY
specify the inbuilt protections in DG
transformer phasor diagram under load explain it?
