Interested to Buy Any Domain ? << Click Here >> for more details...
During a temperature rise test of a bus duct, it is fed
with 415 volts at 2000 amperes. Why dont we get an electric
shock if we touch the bus bars?
- 7 Answers
- 15118 Views
- ABB, SDBL, I also Faced
- E-Mail Answers
Answer Posted / shivakumara
Dear it's very low voltage generally 5.5 or 10volt will apply and for full load rating of busduct,
One more thing is that we will short 3 termilas or busbars in HEAR RUN TEST, due to that temperature will rise upto stabilizing we need to check accordingly with standards that you referring IEEE or IEC
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
sir pls send the je exam - 2008 and other model question papers..
What is size 00, 01, 1 etc., in HRC fuse types?
why capacitance effect is predominant in underground cable transmission and inductance effect is predominant in over head line transmission?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
what is the clear formula to calculate cable size for a load
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
What is EHT tariff or Power factor Tariff ????
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
Why did lightening arrestor solid copper rod head is sharp on mobile tower top?
what is the principle of operation of tungstun bulb ??
how much allowable resistance that can be difference in motor all coils?
How to calculate energy stored in an inductance?
whate is the meaning of balance/unbalance,in stabilizers type
