what is the CT & PT. where is it uses.what is the using that plese kindly answer me...?
- 4 Answers
- 4506 Views
- Cap Gemini, JLL, I also Faced
- E-Mail Answers
Answer Posted / abhishek giri
CT and PT are the devices i.e. current and voltage transformers used for protection and metering purpose in the HT/LT system.Sensing current from Current and voltage measures the parameters on relational basis
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Dear all i am kumaravel. now in chennai. my work is control and relay panel auto cad designing.up to 11kv to 400kv then question is i am improving my knowledge. i want some books name and auther are available for this C&R panel related. plese any one help me
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
What is the Minimum winding resistance of motors ( small & big)? referance range
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
how ct burden,magnetising current,ratio and knee point voltage are related & derived
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
Give me the calculation steps to design an electromagnet to be work in 230V 50 Hz AC Supply. Also give force that is created by that electromagnet when it gets energized.
what are the tests comes under the type test, what tests comes under routine tests.
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
Why we do 2 types of earthing on transformer (ie:)body earthing & neutral earthing , what is function. I am going to install a oo kva transformer & 380 kva dg set what should the earthing value?
Generator,motor and alternator Working principal Please explain easily
Define resonant frequency?
how to calculate the earth fault current
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
