Interested to Buy Any Domain ? << Click Here >> for more details...
my project load is 6 MW so please suggest the size of cable.. ALU 3c 400 aqmm cable can be sufficient.. is there any thumb rule for calculation of cable size please help me
- 1 Answers
- 2448 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagesh.patwari
Yes there's a thumb rule for cable size calculation for 1sqmm Aluminum cable can carry 2Amps and 1 Sqmm Copper wire can carry 4 Amps.
However the cable size increase above 100 Sqmm this thumb rule can not be considered. You need to refer the cable size calculation chart.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is frequency response?
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
What is the feedback in the control system?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
what is mean by transition resistance of transformer?
use of PIR in ehv breaker
Explain the method to keep noises low in a control system?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
Why do not we prefer non conventional sources of energy to conventional sources?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What is the bundle conductor?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
What is meant by analogous system?
WHY THE DIMENSION OF TWO SAME RATED MACHINE IS DIFFERENT ?
