As a good company employee, can you report your supervisor
to the company management if he or she is going against the
company interest in his or her actions?
- 3 Answers
- 25275 Views
- I also Faced
- E-Mail Answers
Answer Posted / srinivas cnu
I believe my first step would be to talk to my supervisor. I would need to understand what he/she did and why and then reason with him/her to set things straight.
If this doesn't work out there is still time to talk to my team leader.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
please give some hindalco placement papers for written exam
how tto ingress mw in turbine explain.procedure ?
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
DG cranking voltage?
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
difference between high and low impedance BUS BAR relay??
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
Hello sir i m student of gtu .what is idp.
Define the three phase formula fuse.
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
dg earth connect only in the amf panel or not why
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
