What is the selection criteria of Natural Draught Cooling
Tower and Induced Draught Cooling Tower . Where we prefer
NDCT and where IDCT.
- 4 Answers
- 15151 Views
- IRCTC, Lanco, I also Faced
- E-Mail Answers
Answer Posted / suresh sarma
Major factors are :
1. type of Load:- NDCT need consistent load and are not very suitable for part load since the draft is a function of exit air temperature which is a function of hot water. hence mostly used in power plants.
2. NDCT need higher pumping head to provide a proper D/H ratio.
3. NDCT size becomes bigger in dry climate because of low RH. NDCT operate on principle of buoyancy or chimney effect and hence dry and hot weather are much less suitable for it and increase the required size and cost.
4. Time of construction is much more than an IDCT.
5. They are more suitable for larger Ranges and longer approaches.
6. Is generally a concrete structure and requires special equipment and manpower.
7. NDCT performance is directly badly effected by wind speed.
many other finer parameters are there. please read difference between NDCT and IDCT IN https://www.gtpl.co.in/files/Comparison%20between%20Natural%20Draft%20Cooling%20Tower%20and%20Induced%20Draft%20Cooling%20Tower.pdf
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is difference between conjugate beam and continuous beam ?
Which factors influence the type of fracture in failure of a material ?
what is the procedure to start the turbine?
What is the use of multi tester?
What is the jet plane?
While finding the velocity of gear B , in case of a simple epicyclic gear train, why do we take tke velocity of gear A to be ZERO(0)if the arm is rotated with speed equal to that of gear A and in opposite direction?
What are the characteristics of Freon 12?
What are the causes of L.O. high temperature?
What do you measure in the banana and mountain diagram?
Anybody please send me the papers of the reliance exam (apti and tech) so that i can go through it) mail me at raminder_verma@rediffmail.com
what are the major duties of a mechanical engineer in a power plant.?
hai this is sreenu...i also applied for the post of PO in syndicate bank..
What is booster in pneumatic ?
Distinguish between the shear center and elastic center.
what is line balancing
