What is RTCC in a transfomer and specify its function.
- 11 Answers
- 111156 Views
- MCB, Vodafone, I also Faced
- E-Mail Answers
Answer Posted / nndkumar
#1. AVR (Automatic Volatge Regulator- an electronic
programable device). With this AVR we can set the Output
Voltage of the transformers. The Output Voltage of the
transformer is fed into the AVR through the LT Panel. The
AVR Compares the SET voltage & the Output Voltage and gives
the error signal, if any, to the OLTC through the RTCC
Panel for tap changing. This AVR is mounted in the RTCC.
#2. RTCC (Remote Tap Changing Cubicle):This is a panel
consisting of the AVR, Dispaly for Tap Position, Voltage,
LEDs for Raise & Lower of Taps relays, Selector Switches
for Auto Manual Selection... In AUTO MODE the voltage is
contrlled by the AVR. I manual Mode the operator can
Increase / decrease the voltage by changing the Taps
maually through the Push Button in the RTCC.
#3. OLTC is mounted on the transfomer. It consits of a
motor, controlled by the RTCC, which changes the Taps in
the transformers.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What happen in ups if phase reverse?
what is the soft starter principle? how is connection diagram? what is the procedure for checking the connection?
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
please send privious years question papers of jindal steel and power ltd.My e mail id is rajanikant.sngh@gmail.com
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
how to calculate percentage impedence at 75 deg C at normal tap
how to calculate units consumption for a 12 hp motor /hr.
what should be correct gas pressures to be a 1.5 ac unite
What will be the voltage regulation of a full load and 0.80 power factor lagging load transformer when a two winding single phase transformer has a voltage regulation of 4.5% at full load and unity power factor?
Why compensation is necessary in feedback control system?
What are chief characteristics of state-space method and its techniques ?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
On what principle electric motor works?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
