Interested to Buy Any Domain ? << Click Here >> for more details...
how will calculate the winding ohmic value in 3phase motors
in h.p wise?
ex.10 h.p motor winding value ph to ph ?
5 h.p motor
any calculation please send me.
- 1 Answers
- 6371 Views
- Hyundai, I also Faced
- E-Mail Answers
Answer Posted / vipul suthariya
There is no any particular equation for motor to calculate winding resistance for calculating motor winding resistance open the terminal box of the motor and connect two probe of the multimeter to two different phase of the motor and meter shows the phase to phase windindg resistance.for lower HP motor higher winding resistance and for higher HP motor lower winding resistance and on the basis of that motor no load current depends and no load current should be 30to40 percentage of the full load current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
write encoder 17 pins details? pin a;b+, pin b;w+,..pin s & t. what is the meaning of b+, w+? explain;
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
If breaker is undefined position, first step to do.
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What is PQA???Applications........
Discribe type of fault in DOL and stardelta startor.
what are the safety measures of induction motor?
Percentage losses in power generation?
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
Write the force balance equation of ideal dashpot element.
sir am giving jspl exam on 19th oct . i belong to eee, so plz send previous question papers ..........to dis id abhilash203@gmail.com
how much LT load can bear by the 100 KW HT connection.
how to design the heater in temperature control unit to heat 50KL of water?
