Why dc supply is used for closing and tripping coil of ht
breakers. What happen if we use only ups ac supply only.
Answer Posted / ankit
dc supply is used because response time in dc supply is fast as it does not have positive negative sinusoidal wave like ac supply
and in ht we need very fast switching in microseconds
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
clarify types of motor operated valves and advantages
Why we use ups battery and dsdb battery in thermal power plant
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
what is difference between isolation and ultra isolation transformer?, what is the method of testing ?
Define the three phase formula fuse.
can some one clearly explain why -48 volt DC use in telecom site????
what is the ground fault relay,which purpose it will be use,clearly tell me plz
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
What is difference between slip rings and carbon burushes?
why the carbon brushes are broken in srim while the motor runningtime
WHAT IS LOAD CELL
How to decide whether A / B / C / D curve type MCB should be used?