Interested to Buy Any Domain ? << Click Here >> for more details...
If u have 60KVA UPS, than tell me how systems ( computers )
u may connect?
- 3 Answers
- 6288 Views
- Thomson Reuters, I also Faced
- E-Mail Answers
Answer Posted / i h rao
Computers are working on DC power supply. If the DC conversion if suitable for 60 cycles then there will be no problem. Normally, DC power supply units are designed for both 50 and 60 cycles. Cycles depend on the RPM of the Alternator. Less the RPM less the cycles.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
what is meaning of bus riser
what is consequences of neutral and earth connect?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What is the difference between alternator and generator?
What are differences between Voltage, EMF & Potential difference ?
What is resistance reading of earth copper rod with grid and without grid?
what are the application of over current relay?
What is EHT tariff or Power factor Tariff ????
Refernce currents are to be generated using refernce cueernts how can this be done??
all details of DG UPS HVAC
why is the power generator connected as star earthed or star earthed through reactance and what its features ?
What Maximam Gap Taibaar & Bush
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
what is the criteria for selecting fuse rating in 1phase, 2phase & 3phase welding sets?
