Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / amar
Bus bar is a metal strip junction which provide connection between incomer and outcomer.it is Generally used where one or two incoming and large no of outgoing are there. If we provide connection between them by twisting of wires junction will heat and burn after sometime. Bus bar designed on the basis of current carrying capacity
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
distribution is maximum done by a)radial b)network c) parallel d)b & c
why generator efficiency is more in swinburnes test?
Single phase and threephase power calculation
Is there any Electrical supervisor license which gives permit to work whole India rather than individual state??
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
can i connect wavetrap in 2 different phase in EHV line?
why connecting surge unit in contactor coil
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
why electronic instruments is more favorable than electrical?
What is the drawback of static coefficients?
Dear all, I just want to ask an expert on this forum for some insights. For the magnetic balance test, when applied voltage on a Delta-Star transformer e.g. Dyn11, the following relationships apply for HV side: 1. H1-H2 = H2-H3 H3-H1 2. H2-H3 = H3-H1 H1-H2 3. H3-H1 = H1-H2 H2-H3 For the LV side also: 4. X1-X0 = X2-X0 X3-X0 5. X2-X0 = X3-X0 X1-X0 6. X3-X0 = X1-X0 X2-X0 Is there a similar pattern for Y-d, Y-Y, D-d? And how about Y-z, D-z, Z-y transformers? I've tested a YNzn5 transformer and for LV side I don't see the pattern. In this particular case I got for LV side the following (see values below): H1-H0 H2-H0 H3-H0 X0-X1 X0-X2 X0-X3 128.0 119.9 7.2 29.2 13.3 15.8 70.7 128.4 59.2 23.4 22.0 3.6 7.2 120.1 128.1 13.4 29.3 15.8 What is the relationship here for LV? For row 1 I see the relationship, for row 3 I also see but it's shifted, but for row 2 I don't see such relationship. Any suggestions, answers, someone?
