Interested to Buy Any Domain ? << Click Here >> for more details...
why the 4 terminal are named as main, line, common, voltage
(M, L, C, v) of a wattmeter??
why not its nameed as A,B,C,D??
- 6 Answers
- 45247 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / deepika
The three terminals are M, L, C, V
M stands for main load, L for connecting load, C for common, V is for voltage
There are two coils - current coil is between M and L, potential coil is between C and V
| Is This Answer Correct ? | 17 Yes | 3 No |
Post New Answer View All Answers
what is rocking arrangement in arc heating
What mean by MLTP
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
difference between Ac and Dc mcb ????
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
which fault is severe and why?between lll fault and lllg fault which fault is severe and y?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
What is different between Circuit breaker and Isolater?
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
What is the relationship between voltage,current & frequency?
What is meant by bus bar protection?
How to test lightning Arrester?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
