ohms law is applicable for dc or ac current or for both???
explain it berifly??
- 3 Answers
- 4830 Views
- I also Faced
- E-Mail Answers
Answer Posted / e.subhash
cant use every place some limitation is there.
Ohms law is most applicable for only DC system.
As per Ohms Law I = V/R , V=IR AND R=V/I
In DC power system only resistance come to circuit
In AC system resistance,capacitance and inductance come to circuit.
so here Instead of R considered Z (impedance) Z= R+XL+XC.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are test signals and their significance?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
Define early construction of human being
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
What is rotary phase converter?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What is the efficiency during maximum power transfer?
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases slip A does not alter B decreases C increases D none of above
What is difference between safe PLC and normal PLC
what is the calculation involved to design the heater to heat 10KL of water in temperature control unit?
how much UPS neutral erath leakage current.
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
