During Validation study, Recovery is passing at all levels
but Linearity is failing. Justify?
- 1 Answers
- 3958 Views
- Mylan, Torrent Pharma, I also Faced
- E-Mail Answers
Answer Posted / p.chandra sekhar reddy
First we have to prove method is linear by linearity parameter then only we have to go for recovery by accuracy parameter.
But as per ur question accuracy performed first after that linearity failed.
If recovery pass in all levels means definatly method should be linear.
But it happens only in higher levels above 10℅ level, some times in lower levels below 10℅ level impurities areas will be fluctuate .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
If vendor having more imp than monograph then how to proceed? and how to set spec?
What are usp limits for theoritical plats,resoution,tailing factor,peak to valley ratio
WHAT IS THE PURPOSE WE USE HCL, CHOPPER, BURNER, MONOCHROMATOR in AAS? PLEASE EXPLAIN BRIEFLY
why we use Dichlorobenzene.nitrobezine.t-butyldi sulhate.for calibration of gc Head space
Identify problem faced when mass spectroscopy is used with HPLC system ?
could negative ions be produced by bombardment process in mass spectrometry?
WHY given much noise PDA dector then VWD Dector
what is the principle of UV Vis spectroscopy, AAS, ICP OES,ICPAES, ICP-MS and FTIR
2. Two grams of Benzoic acid are dissolved in 200 ml of water and extracted with 200 ml of diethyl ether. The distribution coefficient of benzoic acid is 100, and its dissociation constant is 6.5 10-5. Calculate the distribution ratio (D) of benzoic acid at pH 2, 5, and 6. 3. Calculate D at pH 2 to 10 (1 unit apart) in the above problem, and plot D versus pH.
in dissolution why pool sample needed? in which type of drug pool sample need?
why lactose has less charges when packed in steel containers when compared with packing of lactose in polyamide material?
How we performed the force degradation for drug substance, is any specific guideline is available for each parameter(Acidic, basic, oxidation,heat)? what conditions you mentained for above parameters.
if your product is soluble in 0.1n hcl and water then which you choose as media from these 2 media?
Why dissolution test is not performed in all of the products
how a particular wavelength can be different for a particular compund while analysing by uv and by HPLC.
