why control circuit voltage always chooses to be 110v and
220v? and in where it is 110v and 220v? and in where it AC
and DC?
- 2 Answers
- 5646 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagesh.patwari
Agreed with above answer additional missing information is control circuit vtg is DC fed from battery bank provided in the substation
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
while starting a liquid starter ,is there any volage drop on water/soda on tank.can we touch the tank on starting?
Please provided formula for calculate the cable size from step up transformer to M.V panel, run overhead aluminum cables, total load is 5mega watt, total length 900 feet.
Why collecting electrode of ESP to be earthed
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
How time response of the system is divided?
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
what is the question paper model for section engineer in RRB
What is the maximum operating temperature for a thermoplastic insulated cable?
Post possible questions for Power Factor Panel FAT / SAT
What is dc current source? Differentiate between ideal and non ideal current sources?
how to control the speed to switched reluctance motor
EXPLAIN METOD OF IMAGE OF TRANSMISSION LINE/ WHAT ARE ITS PRACTICAL APPLICATION?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
if sf6 gas low in gis what will happen
