Why perform dissolution multimedia study in dissolution
Development
- 4 Answers
- 18981 Views
- Cipla, Optimus, I also Faced
- E-Mail Answers
Answer Posted / manas
since body consist of different mediums,we perfom disso test in different media to make sure which media is suitable for a specific entity(drug) to give a maximum dissolution disso graph/value.
Taking into acccount of a new drug formulation when we are not sure about the media to perform disso or not specified in OGD,so multi-media disso is recommended to make sure of the disso media for a drug.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
if peak get problamatic then what require to do?
WHAT IS THE PARAMETER FOR THE SELECTION OF MOBILE PHASE IN HPLC?
how require to interprit the method precision data of hptlc?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
could negative ions be produced by bombardment process in mass spectrometry?
inhouse product is in capsule form in combination and RLD is in tablet form then can we proceed for multimedia CDP? in inhouse capsule product disso is paddle with sinker in release media is there then RLD product in tablet form then with same as paddle with sinker we can proceed n.a.?
why digestion require in icpms?
Why sometime potassium ortho phosphate mix with acetone use for sample preparation for hplc
What is control room temperature and which guide line says?
what are the guidelines for analytical method validations?
How can we confirm the HPLC column is end-capped or not? Is it possible to identify by physical appearance?
why does used dry caffien in HPLC calibration?
Principle of single pan analytical balance
how to set sample and standard concentration in RS method?
how to qualify the impurity?
