Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know how to measure the earth resistance? if so
explain it
- 42 Answers
- 178049 Views
- ABB, BEL, BridgeStone, College School Exams Tests, Dalkia, Dalmia Group, DEC, Electrical, Genpact, HEC, IOCL, JLL, L&T, MSEB, Saraca, Sical, Telecommunications, University Exams, I also Faced
- E-Mail Answers
Answer Posted / ramesh baraskar
In this meter there will be four terminals(E, P1, P2, P3)
in which E and P1 will be shorted and connected to the grid
or electrode and P2 and P3 are reference electrodes which
will be kept on the earth surface on 90° degree
locations for taking the reference resistances of the earth.
The meter shows the resistance of the earth. But it is
neccessary that it should be below 1ohm and grid earth system below 5 ohm.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how technical is calculated in 11kv line and lt line
Match the following a)(X'+Y') b)X'Y' C)XY 1)NAND 2)NOR 3)Carry
Yazaki india pvt ltd interview questions qurey related
circuit diagram of trip circuit supervision relay
What is a surge supressor why its is used in synchronous generators
what is the meaning of number in (11, 31, 61,14, etc. CDG11, CDG31, CDG61, DDT32
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
PLZ sent the previous year question paper for GET in NHPC on my EMail id ppshanker@gmail.com
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
working principle a.v.r. ?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
what is value of Jin transformer
