Answer Posted / navdeep patil
An Under Voltage coil is used to remotely trip a circuit breaker and some switch disconnectors. Schneider Electric uses the abbreviation MN for Under Voltage coils. An Under Voltage coil has to have a voltage applied to it to enable the device to close, and have the supply removed from it to trip the device.and also provide protection against under voltage.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What current position are you holding in your current company?
what is meant by directional earth fault and non directional earth fault? describe both.
The SFC of an engine is 0.25 kg/kW hr. when the fuel used has a calorific value of 36000 kJ/kg. the thermal efficiency of the engine is
Why is better to have a minimum ceiling voltage of 250% than 160%?
Why the power factor improvement is so important in industrial loads
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
What is the feedback in the control system?
stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate
For a stable system, where should the poles of a system be in a root loci plot?
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
What’s electric traction?
What is step signal?
how electical engineer is related to apsrtc (general) post? if they ask a question in interview as why did u choose this job what shd be answer
can mini-curcuit supply MIL-tested transformer !
what is mean by dry frequency