Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using 190x90x90 mm of brick size?
- 3 Answers
- 15036 Views
- HCL, MPSC, I also Faced
- E-Mail Answers
Answer Posted / amit soni
You all guys know it is nominal size 19 x 9 x 9mm and its IS standard, but in execution of works we use 23x11x7mm/ or 220 x 100 x 8mm different modular & non modular sizes in different states, but main thing is that the volume of 1 brick should matched with 19x9x9mm in all conditions
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is Bearing Capacity,How to determine it?
What are the reasons for geotechnical site investigations in uganda?
How can calculate the requirement of steel bars of rcc slab for 1100 sq ft?
How much does it cost for a R.C.C cover slab of size (450mmX 600mmx 100mm) double rf net given in feets using hand mix concrete?
What are the phases inspections are done by local authority while construction?
I Want To Know Quantity of Cement Conc. & Sand in Column of 9"x9"x10'
Which stone is best for wall construction Laterite Stone or Cement Blocks
Reinforced concrete: suppose you are doing rough estimate for purchase of rebar for reinforced concrete slab for single stores residential building. You know total concrete volume will be 100 m3. How many tons rebar 6, 10 and 12mm will you require for the project?
can you give me the details of rate analysis of steel and concrete?
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
What is demising walls?
How do You Maintain a structure after getting cube test of low strength.
estimate quanitity of bricks(19x9x9cm without mortar), cement & sand in 10feet X 10feet wall ?
A Cat excavator loader of 3Lm*3 heaped capacity bucket is to be used to load blasted rock directly into a crusher of capacity (consumption) of 100L
how to determine H- zone in a column? where it will occur?
