Answer Posted / hanumanth reddy

here two cases will arise.if supply voltage is constant the hysterises loss will decrease and eddy current loss constant.Then total loss will decrease.
if supply voltage is not constant means voltage also increases proportional to the frequency the eddy current losses and hysterises loss increases.

why connecting surge unit in contactor coil

1873

---

how many joints are allowed in underground HT cable of 1 KM

1868

---

Transmission through a short line depends on

2252

---

we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?

1731

---

Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this

1735

---

Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz

3909

---

Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer

3624

---

WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.

2657

---

What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?

2235

---

what r the checklist while installing a 380 kva DG set

3794

---

what is meant by impedance & transient protection?

2104

---

how to find three phase complex power in per unit and MVA?

2178

---

Name a govt approved university which have 100% online engineering course.

1711

---

a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5

1701

---

explain comutator action in detail.thanks

2250

---