Interested to Buy Any Domain ? << Click Here >> for more details...
Is your generator is automated or manual if so do you know
the circuits?
- 7 Answers
- 36329 Views
- RRB, I also Faced
- E-Mail Answers
Answer Posted / singadurai58
Its very simple
Take an 230v auxillary contactor with 1NO POINT and 1NC POINT
One single phase connect at one side NO POINT and other end connect to contactor A1(NO VOLT COIL).A2NEUTRAL directly connected.
Positive (+) supply24 v connected at NC POINT one side and other end connected at generator starting switch .
When EB powersupply is there the contactor is on.
When EB supply cut through NC POINT the positive supply passing to the switch so the generator is on.
Its very cheap.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Which material is used for the core of a transformer and why?
What are the factor to be consider for CT selection in 132kV substation?
why and how current drawn by battery charger depends upon the altitude where it is located?
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
Why is better to have a minimum ceiling voltage of 250% than 160%?
defult setting in p220 micom motor proction relay for 11kv,640kw,f.l.a.-40a,1440rpm ht motor?
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
tell me about roaster switch .& what is the function in transmission & distribution?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
For a stable system, where should the poles of a system be in a root loci plot?
what is the ckt diagram of a tubelight and is it the simplest ckt of electrical engineering and also the component?
