Interested to Buy Any Domain ? << Click Here >> for more details...
there is one orifice plate already installed on 3" line, but
my previous engineer(who is not working here) removed that
tx, but now i want to take it in to the process, so now what
i have to do now? flow fluid is hytherm oil of temp. 260deg
& pressure is 3bar.
- 2 Answers
- 5806 Views
- I also Faced
- E-Mail Answers
Answer Posted / jigaranadkat
Dear Nitin,
Ideally you shall have all the records, but in case if you do not have the records then try to recalculate the DP value using orifice sizing. You can get data for process condition from your process engineer and B (beta value / bore i.d. from orifice plate itself).
If you do not know how to calculate DP the please forward all the process condition with Line size, Line schedule and B beta value to anadkat.jigar@gmail.com. I can recalculate it for you.
Hope this will help you out.
Best Regards,
Jigar Anadkat
anadkat.jigar@gmail.com
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to fix back the valve actuator stem
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Explain how thw analog to digital converter works with the circuit diagram
what is cems analyzer explain with principle and drawing ?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
What is PDS and PDMS ?
How can measure flow in oil line?which type of transmitter is generally used?
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
how to calibrate corollaries (Mass flow meter)?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
all types of liquid analyzer principle with drawing?
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
give some question relative instrument fitter?
