Answer Posted / fareed

1% of qty of reinforcement

Suppose you planning to paint newly fabricated workshop building made of structural steel of 10 tons total mass. How many litters paint primer for 1 coat and 2 coat of top coat?

3512

---

Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa

2212

---

pls tell me , what is the water content

2233

---

How to do base isolation using ETABS software?

2986

---

In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.

3997

---

I have to design brick column and footing (note: without any reinforcement). Can somebody post me the design or suggest a book where i could possibly find the design? Plz help very urgent

2231

---

150mm bricks size how many use 4.14 m3

1897

---

please give the detail design for the soring and shuttering for 8.5m deep excavation in the sandy soil for 25x10 rectangular streaches

2576

---

What applicable rate of wct in bihar

1846

---

How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?

1823

---

why the openings of sieves are square io size?

1625

---

Explain the latest method to detect a crack in a building?

1178

---

How to increase a bearing capacity of soil?

1145

---

why are you joining in this (applied post) job and your aim for this job

2673

---

What is GSB gradation

2506

---