Interested to Buy Any Domain ? << Click Here >> for more details...
why does chattering take place in ac contactors?
can it be avoided & what care does the manufacturer take to
eliminate this phenomenon????
- 10 Answers
- 55965 Views
- I also Faced
- E-Mail Answers
Answer Posted / korra
Can be either one of these;
1) Low voltage condition.
2) Improper armature alignment.
3) Broken shading coils.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
State angle criterion.
What is meant by cold loop test in instrument
he compression ratio for a petrol engine generally lies between
what is meant by neutral compensation factor and where it is used
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
What is different between resistance grounding system and resistance earthing system?
What Normal(Tangent) towers and Tension(Cut-point) Towers?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
one split ac how can told of this ac which Tr tell me us
What are the difference between CT/PT operated Meter and RRAMR Meter for HT/LT application?
what is circuit breaker in transfomer and where it used
What is transister define the transister ammiter ,base, colector.
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
