Interested to Buy Any Domain ? << Click Here >> for more details...
how do we find the nos of bricks in 1 m3 brick masonary
- 16 Answers
- 99085 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / sushree
If the dimension of brick is 230*110*75
den for 1cum 527 bricks are used.
soln-1/0.23*0.11*0.075=527.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why are pull-out tests performed for soil nails?
Normally in slabs, steel quantity is not added when you calculating concrete quantity for that slab, why it is not added ?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
RR masonry rate analysis
What is the amount of work done by a carpenter, bar Bender and plaster Mason in interior and exterior plaster
what is the water cement ratio? how to calculate it? list the wt. of constructions materials including concrete both ordinary and light wt. concrete
Basic questions of civil engineering
Water filter calculation formula
What is diversion tunnel in a dam?
why the cracks occurs in NP3 class Hume Pipe ? And what is bearing capacity of it?
How we can calculate the cement, sand,bricks , water , quintity in 1:6 Ratio 1 cubic metre b/w and 1:4 Ratio in 1 Squre metre b/w????
how to workable concrete cube test M-25 design mix
what are the types of design? which type of method is used at what type of design & why?
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
Providing ,Cutting, bending and positioning of TMT Bar with cost of binding wire
