explain why tap changer is always connected to high voltage
winding side of the transformer.
- 10 Answers
- 40982 Views
- IOCL, UPPCL, I also Faced
- E-Mail Answers
Answer Posted / brajesh kumar chaudhary
Tapping ka main work voltage ko jarurat ke anusar voltage ko badhane ya ghatane ke liye hota hai. aur isko secondry side me lagate hai
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is error of a measurement?
what is lumped and distributed elements?
How could I get a certificate of competency as Electrical Supervisor? I have completed By BTech in Electrical this year(2012) for VJTI Mumbai Maharashtra. Is it compulsory to be produced while joining?
What is the reason that the humming sound is coming from the induction furnace panel?
what is the function of impulse relay
explain the mode of metal iranafer in Co,welding
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
what is reactive power?, why its measured in VA ? is it transient behavior of system?
full form of electrical?
What is domestic transformer? Draw the connection of domestic transformer.
Why different Pressure switch used in marine boiler water circulation system
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
why we r not earthed Control cable of C.T. terminals
what is a bus riser in power system and why it is used
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
